|
Following are several technical presentations which
provide further information on our products, as well as examining some of the
applications in which they are being implemented.
WANTED: High Reliability Back-up Power Solutions
Online seminar: Broadcast Date: November 12th, 2003
Traditionally back-up power systems have used batteries as an energy source
in a wide range of applications. Are there higher reliability alternatives
that require less maintenance, less special infrastructure, less space, higher
power density, greater predictability of condition and are more environmentally
friendly? The answer is yes if you incorporate ultracapacitors into your system
design. Attend this web cast to learn how to design ultracapacitors into back-up
power systems for short term bridge power, power quality ride through and optimized
secondary sources. The system designer can learn how to address packaging and
balancing for high reliability, dynamic charging for rapid recharge and DC
boost conversion to optimize ultracapacitor energy.
Optimizing Energy and Power in Emerging Electronic Products
Online seminar: Broadcast Date: October 29th, 2003
Historically, power and energy needs have been provided
by a single component, forcing designers to compromise between the two requirements.
Emerging electronic products have more features, and therefore more severe
power requirements, yet must still meet the customers´ expectations
of low prices and top-notch performance. Are there alternatives to the expensive
high power batteries that are needed to meet the power and energy requirements
of new products? The answer: split the requirements AND the solutions by
caching power.
Design News Webcast: What's Driving Automotive Design Today?
Online seminar: Broadcast Date: September 24th, 2003
From drive by wire and brake by wire, to collision avoidance
and navigation systems, cars are increasingly becoming electronic wonders.
Electronics are replacing traditional mechanical systems in cars today and
for good reason. They're efficient, economical and they don't take up much
space. During this webcast, Paul E. Teague, National Editor of Design News
leads the discussion as industry experts take you behind the scenes and review
the latest technology in automotive design today.
|
